Evaluating silicosis risk: Assessing dust constitution and influence of water as a primary prevention measure in cutting and polishing of silica agglomerates, granite and marble

Environ Res. 2024 Mar 22:118773. doi: 10.1016/j.envres.2024.118773. Online ahead of print.ABSTRACTAn increasing number of silicosis cases have been reported related to the use of silica agglomerates. Many studies agree on the severity of this disease, which often presents with severe clinical forms in young workers and after a short latency period. Are there differences in the composition of dust generated by cutting and polishing with silica agglomerates versus granite and marble? Does the use of water injection reduce the risk associated with the use of these materials? We carried out a comparative observational-analytical study, measuring the concentration of dust generated during different machining operations on three different materials: granite, marble, and silica agglomerates. The effect of water injection on dust generation was evaluated. Personal sampling pumps were used, connected to a cyclone with polyvinyl chloride filters. The flow rate of the pumps was adjusted using a piston flowmeter. Measurements with a cascade impactor were made to assess the size distribution of respirable crystalline silica particles within the respirable fraction. In addition, environmental measurements with a spectrometer were made. 10 tests were carried out on granite and silica agglomerates for each procedure. In the case of marble, with very low silica content, only 2 tests of each type were carried out. Duration of each measurement was between 6 and 25 min. Cleaning times were set f...
Source: Environmental Research - Category: Environmental Health Authors: Source Type: research