3D Printed Lung Phantom for Individual Monitoring

Health Phys. 2024 May 1;126(5):292-295. doi: 10.1097/HP.0000000000001777.ABSTRACTThe Human Monitoring Laboratory, Health Canada (HML), has used a 3D printer to re-engineer its Lawrence Livermore National Laboratory (LLNL) foam lung sets (manufactured by Radiology Support Devices, Inc., Long Beach, CA). The foam sets are currently the HML standard for calibrating and performance testing lung-counting systems in Canada. This paper describes the process of creating and validating new 3D-printed lung sets modeled from one of the HML's existing RSD foam sets. The existing sets were custom made, making them costly and difficult to obtain or replace. Also, after many years of use, the HML has found that they are prone to wear and tear. When used with planar inserts containing various isotopes, the blank sets can become contaminated and are difficult to clean. Using 3D printing, the HML has created new blank lung sets that are nearly identical copies of the originals and are inexpensive and easily manufactured. Measurements using natural uranium (Nat U), 241Am, and 152Eu planar lung inserts were performed to compare obtained efficiencies at a wide range of energies using the original RSD foam sets and the 3D-printed ones. Both the foam and the 3D-printed lung sets were counted using the LLNL chest phantom positioned in the same counting geometry in the lung counting system. Biases, all below 15%, were obtained between the foam and the 3D-printed sets for energies above 40 KeV. Based ...
Source: Health Physics - Category: Physics Authors: Source Type: research