Designing lightweight neutron absorbing composites using a comprehensive absorber areal density metric

In this study, analytical models and a more physically representative simulation evaluated the penalty to neutron absorbing performance due to neutron channeling between large absorbing particles. Models and simulation agreed that B4C particles smaller than 100μm and especially those smaller than 10μm did not cause excessive neutron channeling. A more comprehensive neutron absorbing composite design metric - boron-10 equivalent areal density, which considers the particle size penalty and the matrix contribution to absorptivity - was introduced and used to estimate lightweighting via matrix substitution. Calculations using this new metric showed that a non-absorbing Mg matrix reduced mass by up to 35% over Al, constrained by the difference in mass density, while an absorbing Mg-Li matrix reduced mass by up to 60%, exceeding the difference in mass densities alone. Measurement of apparent absorber areal density through two experimental techniques - foil activation and direct counting - validated estimated absorber areal density as a neutron absorbing composite design metric. This updated understanding of the particle size penalty, newly introduced design metric, and experimental validation demonstrate a path to lightweight neutron absorbing composites.PMID:38382134 | DOI:10.1016/j.apradiso.2024.111227

Source: Applied Radiation and Isotopes - February 21, 2024 Category: Radiology Authors: Andrew O'Connor Cheol Park Wesley E Bolch Andreas Enqvist Michele V Manuel Source Type: research