Sensors, Vol. 19, Pages 4098: Testing Mechanical Properties of Rock Bolt under Different Supports Using Fiber Bragg Grating Technology

Sensors, Vol. 19, Pages 4098: Testing Mechanical Properties of Rock Bolt under Different Supports Using Fiber Bragg Grating Technology
Sensors doi: 10.3390/s19194098
Authors:
Guo
Wang
Ma
Wang

: Fiber Bragg grating (FBG) sensors, which can accurately measure strain, can be integrated with rock bolts with small fingerprints. In this paper, according to the force mechanism of prestressed anchor and non-prestressed anchor, different loading modes were designed, named active loading mode and passive loading mode. Then, FBG technology was used to monitor the axial force variation of prestressed anchor and non-prestressed anchor in different loading modes. Based on the test results, it is found that when the anchoring force is relatively small (<35 kN), prestressed anchors need to be tested by active loading mode, and non-prestressed anchors need to be tested by passive loading mode. For the prestressed anchor, the force condition of the bolt-shaft was similar to that of the two-force bar, and the axial force of the bolt-shaft was nearly the same along its entire length. Taking the applied load as the reference, the change rate of the axial force of the bolt-shaft was less than 10%. For non-prestressed anchor, due to the plate, there is a certain area surrounding the plate where the axial force of the bolt-shaft was greatly influenced. With applied loads of less than 15 kN, the change rate of the axial force on FBG1 was greater than 10%. With applied loa...

Source: Sensors - September 21, 2019 Category: Biotechnology Authors: Guo Wang Ma Wang Tags: Article Source Type: research