Development and evaluation of the iron oxide-hydroxide based resin gel for the diffusive gradient in thin films technique.

Development and evaluation of the iron oxide-hydroxide based resin gel for the diffusive gradient in thin films technique. Anal Chim Acta. 2020 Mar 15;1102:36-45 Authors: Smolíková V, Pelcová P, Ridošková A, Hedbávný J, Grmela J Abstract An ion-exchange resin Lewatit FO 36 was used for the preparation of a new resin gel for the diffusive gradient in thin films technique (DGT). The DGT method was optimized for the accumulation of four bioavailable arsenic species (AsIII, AsV, monomethylarsonic acid, dimethylarsinic acid) in the aquatic environment. The total sorption capacity of Lewatit FO 36 resin gel was 535 μg As disc-1. The microwave-assisted extraction in the presence of NaCl (10 g L-1) and NaOH (10 g L-1) was used for the isolation of arsenic species from the Lewatit FO 36 resin gel. The elution efficiency of arsenic was 98.4 ± 2.0%. Arsenic was determined by the optimized electrothermal atomic absorption spectrometry (ET-AAS) method using palladium modifier, pre-atomization cool-down step and tungsten carbides coating of graphite tube. The Lewatit FO 36 resin gel provides accurate results (cDGT/cSOL ratio 0.86-1.00) in the pH range 4-8. No significant influence of experimental conditions was observed in the presence of chlorides (0-0.5 mol L-1) and humic acid (0-100 mg L-1). Only a very high concentration of phosphates (10 mg L-1) caused a slight decrease in the diffusion coefficients of MMA and AsV specie...
Source: Analytica Chimica Acta - Category: Chemistry Authors: Tags: Anal Chim Acta Source Type: research