IJERPH, Vol. 17, Pages 784: Effect of Alkalinity on Catalytic Activity of Iron –Manganese Co-oxide in Removing Ammonium and Manganese: Performance and Mechanism

In this study, a pilot-scale experimental filter system was used to investigate the effect of bicarbonate alkalinity on the activity of an Fe–Mn co-oxide for ammonium and manganese removal from surface water. The results showed that an increase in alkalinity to 150 mg/L (calculated as CaCO3) by the addition of NaHCO3 significantly promoted the activity of the Fe–Mn co-oxide. The ammonium and manganese removal efficiencies of the Fe–Mn co-oxide increased from 40% to 95% and 85% to 100%, respectively. After NaHCO3 was no longer added, the activity of the filter column remained. Moreover, pH (7.4–8.0) and temperature (12.0–16.0 °C) were not the main factors affecting the activity of the filter, and had no significant effect on the activity of the filter. Further characterization analysis of the Fe–Mn co-oxide filter film showed that after alkalinity was increased, the accumulation of aluminum on the filter media surface decreased from 3.55% to 0.16% and the oxide functional groups changed. This was due to the action of bicarbonate and the residual aluminum salt coagulant in the filter, which caused the loss of Al from the surface of the filter media and weakened the influence of the aluminum salt coagulant on the activity of the Fe–Mn co-oxide; hence, the activity was recovered.
Source: International Journal of Environmental Research and Public Health - Category: Environmental Health Authors: Tags: Article Source Type: research