Re-esterification of macauba acid oil using glycerol for acidity reduction and biodiesel production

Abstract Biodiesel production using acid oils is an important alternative for biofuel cost reduction. However, it is a huge challenge for homogeneous transesterification, the main industrial route commonly used. This paper presents macauba oil with high acidity, 43.90 w/w%, as a potential raw material for biodiesel production. The acidity was reduced to 0.8 w/w% after re-esterification (80 min) with glycerol at high temperature (235 °C), without catalysts. Zinc (powder and coating) and NbOPO4 were also tested as catalysts in comparison with the reaction without a catalyst. Reactions catalyzed by metallic Zn produced a large amount of Zn carboxylate, an undesirable soap, due to the high Zn leaching. In contrast with the literat ure, Zinc did not show good catalytic activity, as confirmed by the kinetic parameters. NbOPO4 was not a good catalyst, too. Reaction without catalysts was performed using nitrogen as a carrier gas and it was compared with reaction under vacuum to remove co-produced water. Nitrogen showed the best r esult for re-esterification, avoiding degradation reactions. Triglycerides (TG) were the prevalent products in reactions using nitrogen. After re-esterification, the oil was easily converted into biodiesel with high ester content (98.4%) of methyl ester by alkaline transesterification.
Source: Brazilian Journal of Chemical Engineering - Category: Chemistry Source Type: research